Remarque : Les codes d’erreur des i2 ne sont pas documentés par Segway. Ces codes d’erreur sont donc issues de l’expérimentation des utilisateurs.
Error Code Meaning Solution
C100 The Rear CU Board reports : The battery packs do not have sufficent charge to continue safe operation Charge the batteries
C103 The Rear CU Board reports : Power base fault (Possibly temperature problem ?)
C106 The Rear CU Board reports : Power base fault (Possibly low power ?)
C108 The Front CU Board reports : The battery packs do not have sufficent charge to continue safe operation Charge the batteries
C208 The Front CU Board reports : The temperature of the battery packs is too hot or too cold Allow the unit to rest in cool environment
E003 The Rear CU Board reports : (an error)
If the problem keeps occuring, the base needs to be replaced.
E014 The Rear CU Board reports : Power base fault
E015 The Rear CU Board reports : Power base fault
E017 The Rear CU Board reports : Power base fault (May be due to excessive moisture)
E027 The Rear CU Board reports : Fault detected in the battery pack
E042 The Rear CU Board reports : Power base fault
E04A The Front CU Board reports : Power base fault
E04C The Front CU Board reports : Power base fault
E086 The Rear CU Board reports : Power base fault (error in the propulsion subsystem ?)
E100 The Rear CU Board reports : The battery packs do not have sufficent charge to continue safe operation
E102 The Rear CU Board reports : Unable to communicate with the battery pack Swap the batteries front to back.
If error persists, re-calibrate the batteries :
Make sure the battery terminals are clean Make sure the terminals on the bottom of the Segway are clean Drain batteries completely Completely charge the Segway before starting
E10A Power Base failure / other controller is having troubleE10D The Front CU Board reports : Power base fault
E17F The Front CU Board reports : Power base fault (May be due to excessive moisture) * Allow PT to dry completely (if applicable),
Remove and reseat batteries Install alternate set of battery packs. If the same error code is persistent replace the power base or return to factory for service Fault detected in the battery pack attached to me
E205 The Rear CU Board reports : Power base fault (Controller board has a malfunction ?)E407 The Rear CU Board reports : Power base fault If the same error code is persistent replace the power base or return to factory for service
E40F The Front CU Board reports : Power base fault If the same error code is persistent replace the power base or return to factory for service
L’ensemble des codes erreurs (en particulier pour les Segway de première génération) peuvent être retrouvées en suivant ce lien :
http://social.segway.com/mediawiki/index.php/Error_Codes
Autre document interessant à télécharger : Code d’erreur Segway :
Code erreur Segway GEN 2